Rainwater system installation

Scandic® rainwater system installation step by step

Step 1

Prior to fitting the hooks, it is necessary to draw a drain slope to the location of the drill. Preferably, the gutter slope should be about 2 mm for every linear meter. The distance at which the hooks are fitted shall not exceed 0.8 m and the hooks at the ends shall be 0.1 m to the edge of the roof.

Step 2

It is recommended that the gutter be mounted so that the outside of the gutter is 30-40mm lower than the imaginary extension of the roof rafter. In this way, the water flow from the roof will not pass over the gutter.

Step 3

Prior to installation, the hooks shall be bent below the angle of inclination of the roof with a special device, according to the required slope of the drain.

Step 4

At the place marked at the beginning, using a router and then the tin snips, cut out a drain slot in the gutter, which must not be larger than the diameter of the gutter.

Step 5

Two gutters to be joined are placed on hooks and then fixed with the gutter bracket. The distance between the ends of the gutters shall be 2-3 mm to allow for shrinkage/ expansion of the gutters in response to temperature fluctuations (freeze/ thaw).

Step 6

At the inside/ outside corners of the building, the KIB/ KEB pieces connecting two gutters are fitted. Sealing is possible thanks to the brackets included on both corner models.

Step 7

For the installation of downspouts, downspout brackets are mounted on the wall, one below the other. The mounting depends on the type of facade. The maximum distance between two downspout brackets will not exceed 2 meters.

Step 8

The 60-degree downspout elbow is mounted up in the tee and down in the downspout. Their joint is made through a downspout extension. Measure the distance between elbows and add 100 mm for both ends of the downspout extension, which is inserted 50 mm in the elbows for each end.

Step 9

The universal cover is attached to the end of the gutter by hand pressing or with an elastic hammer, without the use of silicone, as this destroys the seal over time.